Featured Post

YouTube and link library for S2D.dk

2020/01/07

Split Mellanox Port and connect to Cisco Switch

Split Mellanox Port from 1x100 Gigabit to 4x10 Gigabit ports and connect to Cisco Switch

*** Disclaimer ***
s2d.dk is not responsible for any errors, or for the results obtained from the use of this information on s2d.dk. All information in this site is provided as "draft notes" and "as is", with no guarantee of completeness, accuracy, timeliness or of the results obtained from the use of this information. Always test in a lab setup, before use any of the information in production environment.
For any reference links to other websites we encourages you to read the privacy statements of the third-party websites.
The names of actual companies and products mentioned herein may be the trademarks of their respective owners.
***

Split Mellanox Port from 1x100 Gigabit to 4x10 Gigabit ports and connect to Cisco Switch

The Example use a Cisco 2360G (4x10 Gigabit Ports) 
Mellanox Split Cable with Prolabs Transceiver, Cisco compatible and has been programmed to match the Cisco Switch 2360G


***
Split Mellanox Port 15
***
enable
configure terminal 
interface ethernet 1/15
shutdown
module-type qsfp-split-4
Yes

For port configuration or reset port, please go to:
Split Mellanox Port from 1x100 Gigabit to 4x10 Gigabit

Mellanox
HowTo Use Mellanox Interconnect Products with Cisco Switches

Cisco Switch show command for idprom and transceiver:
show interfaces tenGigabitEthernet 0/1 status
show idprom interface tenGigabitEthernet 0/1
show idprom interface tenGigabitEthernet 0/1 detail
show interfaces tenGigabitEthernet 0/1 transceiver
show interfaces tenGigabitEthernet 0/1 transceiver properties